A-A-55437
3. Cover. Bags shall be formed from polyethylene tubing or flat film. The
thickness of the film used shall be 0.003 inch. The seams of the formed bag
(back and bottom as required) shall be effected either by an electronic seal,
thermal impulse or other heat seal methods. All seams shall be straight and
continuous and shall be parallel to each other and to the formed edges of the
bag. The tensile strength of the formed seams shall be a minimum of 60% of the
tensile strength of the film itself. Bottom seams and the side seams if used,
shall be positioned along the edges of the bag with the gussets either in closed
position or in the open (extended) position.
4. Load dimensions. Load dimensions shall be outside measurements. A
polyethylene cover (bag) shall cover loads of the following dimensions:
Outside load Dimensions
Type Bag
Type I
112 inches long, by 90 inches wide, by 96 inches high
112 inches long, by 90 inches wide, by 72 inches high
Type II
88 inches long, by 54 inches wide, by 72 inches high
Type III
5. Cover size. Bag type shall be supplied as specified. Cover dimensions shall
be as follows.
Dimensions
Type Bag
Type I
Size 202 +/- 2 inches lay flat width, gussetted to 106 inches
face width by 96 inches gusset, by 141 +/- 1 inch long inside
measurement
Type II
Size 202 +/- 2 inches lay flat width, gussetted to 106 inches
face width by 96 inches gusset, by 117 +/- 1 long inside
measurement
Type III
Size 144 +/- 2 inches lay flat width, gussetted to 88 face
width by 54 inches gusset, by 99 +/- 1 inch long measurement
6. Workmanship. The fabricated bag shall be free from cuts, tears, creases,
cracks or other imperfections which might impair its usefulness. The bag shall
be free from dirt, grit or other uncleanness and shall not block to the extent
that it cannot be readily handled manually.
Regulatory Requirements. The offeror/contractor is encouraged to use recovered
materials to the maximum extent practicable, in accordance with paragraph 23.403
of the Federal Acquisition Regulation (FAR).
Metric Products. Products manufactured to metric dimensions will be considered
on an equal basis with those manufactured using inch-pound units, provided they
fall within specified tolerances using conversion tables contained in the latest
version of Federal Standard No. 376, and all other requirements of this Commer-
cial Item Description are met.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business