INCH-POUND]
MIL-S-9968C(IP)
26 September 1990
SUPERSEDING
MIL-S-9968B(IP)
7 December 1984
MILITARY SPECIFICATION
SKID, COMPONENTS, DOD REUSABLE
This specification is approved for use by all Departments and Agencies of the
Department of Defense.
1.
SCOPE
1.1 Scope. This specification covers runner/header beam, auxiliary tie
bar, and mounting plate components of the Department of Defense (DOD) reusable
type skid used for shipment and storage of metalworking machinery.
1.2 Classification. The components shall be of the following types and
sizes (identified by part numbers). The type and size component to be
furnished shall be as specified (see 6.2).
- Runner/header beam (see figure 1).
Type I
Size - Nominal length 2 through 36 feet long (see table I).
- Auxiliary tie bar (see figure 2).
Type II
Size - Nominal length 2 through 10 feet long (see table II).
Type III - Mounting plate (see figure 3).
Size - 10 and 11.5 inches long (see table III).
Beneficial comments (recommendations, additions, deletions) and any pertinent
data which may be of use in improving this document should be addressed to:
Defense Industrial Plant Equipment Center, ATTN: DIPEC-SSG, 2163 Airways
Blvd., Memphis, Tennessee 38114-5051, by using the Standardization Document
Improvement Proposal (DD Form 1426) appearing at the end of this document or
AMSC N/A
FSC 3990
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business