MIL-S-9968C(IP)
3.2.2 Reclaimed materials. The skid components may contain reclaimed
materials to the maximum extent possible provided such materials will not
jeopardize the intended use, performance; or design life of the skid
components. Reclaimed materials shall have been collected or recovered from
solid waste and reprocessed to become a source of raw materials, as opposed to
virgin raw materials. None of the above shall be interpreted to mean that the
use of used, rebuilt, or remanufactured end products are allowed under this
specification.
3.2.3 Safety and health requirements. All components furnished on the
skid, whether or not specifically required herein, shall be in accordance with
all requirements of 29 CFR 1910. Additional safety and health requirements
shall be as specified (see 6.2). All other manufacturer processes of the skid
that present safety hazards shall be provided when specified and fully
described by the procuring activity (see 6.2).
3.2.4 Environmental protection. During the manufacture, operation, ser-
vice, transportation, or storage of the skid and its components, materials
hazardous to the ecological system as prohibited by Federal, state, or local
statutes in effect on the date of the contract shall not be used or emitted.
Specific environmental protection requirements exceeding the established
regulations as required herein shall be as specified by the procuring activity
(see 6.2).
3.2.5 Interchangeability. To provide for replacement of worn parts, all
parts having the same part number shall be manufactured to definite dimensions
and tolerances that will be functionally and dimensionally interchangeable.
The skid components shall be designed to be assembled and disassembled using
standard hand tools.
3.3 Costruction. The skid components shall be constructed of parts
which are new, without defects, and free of repairs. The components shall
-
withstand all forces encountered during operation of the skid to its maximum
rating and capacity without permanent distortion or failure.
3.3.1 Surfaces. All surfaces shall be clean and free of harmful or
extraneous materials. All edges shall be either rounded, beveled, or deburred
unless sharpness is required to perform a necessary function. Except as
otherwise specified herein, the condition and finish of all surfaces shall be
in accordance with the manufacturer's commercial practice.
3.3.2 Welding. Welding shall be employed only where specified in the
original design. All welding shall be in accordance with the requirements of
ANSI/AWS DI.2 Structure Welding Code, Aluminum.
The sawed out shaded
portion on both sides and the bend up ends of the skid components shall be
welded as specified in figure 1. All welding shall be free of overlap,
undercut, non-fusion, burn through, insufficient weld penetration, and other
defects. None of these operations shall be employed as a repair measure for
any defective part.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business